TM 5-3805-258-24-2
POWER TRAIN
DISASSEMBLY AND ASSEMBLY
71.
72.
73.
74.
TRANSMISSION
Install four discs (89) and three plates (90)
(second speed) in the gear. Start and stop with
a disc.
Install gear (91) as shown.
Install ring (92) in the groove of the shaft with
tool (A) as shown.
Heat carrier (94) to a temperature of 127° to
166° C (260° to 330° F) for a maximum of ten
minutes and install it on housing (95) so the
part number can be seen. Install the pinto hold
carrier (94) in position. Install rings (93) on the
carrier as shown.
NOTE: Use the method below only for non-metal
rings to make them ready for installation.
FIGURE 1. CORRECT METHOD TO MAKE
(NON-METAL) NEW RINGS READY FOR
INSTALLATION
FIGURE 2. WRONG METHOD TO MAKE
(NON-METAL) NEW RINGS READY FOR
INSTALLATION
5-291
