TM 5-3805-258-24-2VEHICLE SYSTEMSDISASSEMBLY AND ASSEMBLYTILT CYLINDER10. Put tooling (E) in position on the nut. Tightenthe nut to a torque of 3100 ± 310 N•m (2290± 229 lb. ft.).11. Use tooling (B) to install cylinder (12) on rodassembly (13).NOTE: The cylinder rod must be fully extendedwhen bolts (14) are tightened. This will keep thecylinder piston and head in alignment with eachother.12.13.14.Install bolt (14) that holds the head to thecylinder.Lower the temperature of the bearings andinstall them in the center of the bores withtooling (F).Install lip type seal (15) with tooling (A). Thelip of the seal must be toward the outside.end by:a) install tilt cylinder5-361
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business