TM 5-3805-258-24-2 VEHICLE SYSTEMS DISASSEMBLY  AND  ASSEMBLY LIFT CYLINDERS REMOVE LIFT CYLINDERS 5102-11 Tools  Needed A B C D 8S7630 Stand 2 8S7641 Tube 2 8S7615 Pin 2 8S8048 Saddle 2 5P3100 Pump Group (or   electric) 1 1 1 6V3175 Hydraulic  Puller 1 1 1 9S5558 Stud,  1  ¼  in. 1 1 1 4K684 Washer 1 1 1 1P544 Nut 1 1 1 9S5433 Adapter 2 5P9736 Link  Bracket 2 6V86 Adapter 1 1P1837 Plate 1 9S5431 Sleeve  Assembly 1 1 1. Use the machine hydraulic system to put the loader  frame  in  position  on  tooling  (A)  as shown. 2. Drain the oil from the hydraulic tank. 3. Remove bolts (1) and disconnect two lines (2) on each side. 4.  Remove  grease  fittings  (3),  bolts  (4),  the spacers and washers from pin (5). 5. Put tooling (B) in position on pins (5). Fasten a hoist to tooling (B) and one to the lift cylinder so they do not fall when the pin is removed. 6. Remove pins (5). 5-362