VEHICLE SYSTEMS
STEERING
6.
7.
8.
9.
10.
11.
12.
Use tooling (B) to pull cylinder (2) away from
the head and rod.
Remove nut (5), the washer, piston (6) and
head (7) from the cylinder rod.
Remove seal assembly (9) and wear ring (8)
and the piston.
Remove seal (11) and backup ring (10) from
the head.
Remove lip type seals (12) and (13) from the
head.
Remove seal ring (14) from the head.
On models 950BSCE and 950BNSCE
remove wear ring (15) from head.
ASSEMBLE STEERING CYLINDERS 4303-16
Tools Needed
A B C D E F
1P510
Driver Group
1
4S9181
Seal Expander
1
6V4948
Hydraulic Cylinder
Repair Stand
1
1P850
Torque Multiplier
1
1P851
Spline Adapter
1
1P852
Male Adapter
1
1P1833
Bearing Puller Adapter
1
9S5559
Stud, 1 in.
1
6V3160
Hydraulic Puller
1
1P543
Nut
1
5F7353
Washer
1
5P3100
Pump Group (or electric)
1
8F2243
Wrench
1
1. Clean and inspect all parts. Make a replace-
ment of all parts that are worn or damaged.
2. Install inner seal (4) in head (1). The inner seal
does not have a lip and can be installed either
way. Install middle seal (3) with the lip in. Use
tooling (A) and install outer seal (2) with the
lip out. Put clean oil on the seals.
2A. On models 950BSCE and 950BNSCE install
wear ring (15).
TM 5-3805-258-24-2
DISASSEMBLY AND ASSEMBLY
CYLINDERS
5-377
