TM 5-3805-262-102-18. PREPARATION FOR MOVEMENT (CONT)b. Towing the Loader (Cont).(e) Turn off engine.When performing following step, be sure thatdo so will cause damage to transport bracketand may distort bucket lift arms.engine is off. Failure toand lift cylinder assembly,(f) Place LIFT ARM control lever in LOWER position and slowly lower bucket.Lift cylinder assembly rod will retract and “bucket will lower until rodeye is resting on transport bracket.(g) Go to step (3) below.(3) Place transport/safety link in locked position. If loader is turned toone side and engine is inoperable:(a) Clear personnel from area.(b) Pull SHUT OFF control all the way out.(c) Turn ignition key switch to start position and at the same time turnsteering wheel. When loader is straight, install transport/safety link.Don’t operate starter motor more than 30 seconds at a time withoutallowing two minutes for it to cool.(d) Place ignition key switch in off position.2-61
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
