TM 5-3805-262-102-18. PREPARATION FOR MOVEMENT (CONT.b .TowingtheLoader(Cont).(c)(d)(e)(f)(g)(h)(i)(j)Raise loader lift arms using chain hoist or lifting device.Install transport bracket, stored intool box, on either lift cylinderassembly rod and secure usingcapscrew and nut.Place LIFT ARM control leverin LOWER position. Lift cyl-inder assembly rod will re-tract and bucket will loweruntil rod eye is resting ontransport bracket.Attach chain hoist or other suitablelifting device to loader bucket cen-ter tooth.Place BUCKET control lever in CROWD position and use chain hoist to rollbucket back.Secure bucket assembly in rollbackposition using 12 foot length ofchain with a hook on each end. Po-sition one chain hook on centerbucket tooth and lift arm brace asshown. Place BUCKET control leverin NEUT. position.Disconnect chain hoist or liftingdevice from loader bucket.Go to step (3) below.(2)If engine can be started:(a)(b)(c)(d)Start engine and raise bucket one foot off ground using LIFT ARM controllever in RAISE position then return to NEUT. position.Using BUCKET control lever in CROWD position, rollback bucket completelythen return BUCKET control lever to NEUT. position.Secure bucket assembly in rollback position using 12 foot length ofchain with a hook on each end. Position one chain hook on center buckettooth and lift arm brace as shown.Install transport bracket, stored in tool box, on either lift cylinderassembly rod and secure using capscrew and nut.2-60
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
