TM 5-3805-262-10
3-5. TROUBLESHOOTING TABLE (CONT)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
22. LIFT ARMS DO NOT OPERATE PROPERLY
Step 1.
Park loader on level surface, lower
bucket to ground, turn off engine, and
pull up on parking brake control.
Check hydraulic oil level in sight
gage in front of loader.
Oil level must be seen in sight gage.
a. If oil level is not seen in sight
gage, add hydraulic oil (refer to
LO 5-3805-262-12).
b. If oil level is seen in sight
gage, go to step 2 below.
Step 2.
Inspect bucket lift arm pivot pins and
bushings for wear or damage.
a. If pivot pins or bushings are worn
or damaged, notify organizational
maintenance.
b. If pivot pins and bushings are not worn or damaged, go to step 3
below.
Step 3.
Check if bucket lift arm pivots are adequately lubricated.
a. If pivots are not adequately lubricated, lubricate (refer to LO
5-3805-262-12) .
b. If pivots are adequately lubricated, notify organizational main-
tenance.
3-32
