TM 5-3805-262-10
Section III. MAINTENANCE PROCEDURES
Para
Introduction . . . . . . . .. . . . . . 3-6
Inspection . . . . . . . . . . . . . . . 3-7
Fuel Injector Lines . . . . . . . . . . . 3-7a
Fuel Tank . . . . . . . . . . . . . 3-7b
Radiator Assembly . . . . . . . . . . . . . 3-7c
Battery Cables . .. . . . . . . . . 3-7d
Wiring Harnesses . . . . . . . . . . . . . . 3-7e
Drive Shafts . . . . . . . . . . 3-7f
Loader Bucket Assembly . . . . .. . 3-7g
Bucket Cutting Edge
Assemblies . . . . . . . . 3-7h
Para
Clamshell Teeth Assemblies . . . . 3-7i
Servicing . . . . . . . . . . . . . . . . . . 3-8
Air Cleaner . . . . . . . . . . . . . . 3-8a
Fuel Tank . . . . . . . . . . . . . . . . 3-8b
Air Reservoir . . . . . . . . . . . . . . . . . 3-8c
Checking Tires Air Pressure . . . 3-8d
Windshield Washer Reservoir . . . 3-8e
Removal and Installation . . . . . . . 3-9
Transport/Service
Link . . . . . . . . . . . . . . . . . 3-9a
Engine Side Panels . . . . . . . . . . . . 3-9b
3-6. INTRODUCTION
This section provides maintenance procedures consisting of inspections and servicing
of the various components and/or systems to be performed by the operator as autho-
rized in the Maintenance Allocation Chart.
3-7. INSPECTION
a. Fuel Injector Lines.
(1)
Unlock and remove engine front right side panel (under fender).
(2)
(3)
(4)
(5)
Start engine and operate at idle
engine.
Inspect fuel injector lines at
fuel injection pump and at fuel
injectors for fuel leaks.
If fuel leakage is observed,
notify organizational mainte-
nance.
Install and lock engine right
side panel.
speed for three minutes then turn off
3-35
