TM 5-3805-262-20
11-4. LIFT CYLINDER ASSEMBLIES MAINTENANCE (CONT)
b. Replacement (cont).
REMOVAL (SHEET 1 OF 3)
Dry cleaning solvent P-D-680 used to clean parts is toxic and flammable.
W e a r p r o t e c t i v e g o g g l e s a n d g l o v e s a n d u s e o n l y i n a w e l l v e n t i l a t ed
a r e a . A v o i d c o n t a c t w i t h s k i n,
e y e s a n d c l o t h e s a n d d o n ’ t b r e a t h e
vapors. Do not use near open flame or excessive heat and don’t smoke
w h e n u s i n g i t .
F a i l u r e t o d o s o c o u l d c a u s e s e r i o u s i n j u r y . I f y o u
b e c o m e d i z z y w h i l e u s i n g c l e a n i n g s o l v e n t , g e t f r e s h a i r a n d m e d i c al
a t t e n t i o n i m m e d i a t e l y . I f c o n t a c t w i t h s k i n o r c l o t h e s i s m a d e , f l u sh
w i t h l a r g e a m o u n t s o f w a t e r .
If contact with eyes is made, wash eyes
with water and get medical aid immediately.
(1) Using clean cloth moistened with cleaning solvent P-D-680, remove dirt
and grease from hose connections on lift cylinder assembly. Dry using
c l e a n c l o t h s.
NOTE
P l u g o r c a p h o s e s d i s c o n n e c t e d o r r e m o v e d a n d p l u g l i f t c y l i n d er
a s s e m b l y p o r t s i n f o l l o w i n g s t e p s t o p r e v e n t f o r e i g n m a t t e r f r om
entering hydraulic system.
(2)
( 3)
( 4)
(5)
Attach chain hoist equipped
w i t h n y l o n s t r a p s t o l i f t
cylinder assembly as shown;
take up slack.
Remove lubrication fittings (1
and 2).
Loosen and remove
and capscrew (4).
l o c k n u t ( 3 )
Using hammer and 1-7/8 inches
diameter rod, drive pin (5) out
of loader lift frame assembly
and cylinder rod eye as shown.
11-66
