TM 5-3805-262-20
INSTALLATION (SHEET 3 OF 3)
(15)
(16)
(17)
(18)
(19)
(20)
(21)
If necessary, adjust positioning of hose (5) on hydraulic reservoir port
and tube (4) so that hose is centered.
Position clamps (2) on each end of hose (5) and tighten securely.
Tighten hydraulic reservoir fill cap (1) and close and lock front access
door.
Start engine and operate at 1000 rpm. Operate CLAM, BUCKET, and LIFT ARM
control levers several times to remove air from hydraulic system.
Turn steering wheel in both directions several times to remove air from
steering hydraulic system.
Lower bucket to ground and turn off engine. Check for hydraulic oil leak-
age at tube and hose connections. Tighten connections if necessary.
Check oil level; a dd oil as necessary (page 11-78).
1 1 - 8 9
(11-90 blank)
