TM 5-3805-262-20
REMOVAL ( SHEET 2 OF 2)
NOTE
Perform following steps only if tube (6) and fitting (7) require
removal, otherwise proceed to step (7) below.
(5)
(6)
(7)
(8)
Using open end wrench loosen com-
pression nut (4) then remove tube (6)
by withdrawing through fitting (7).
Remove compression nut (4) and
sleeve (5) from tube (6), then
remove fitting (7) using open
end wrench.
Using open end wrench, loosen
two compression nuts (8). Dis-
connect fuel suction tube (10)
from elbow (12).
Remove fuel suction tube (10) by
withdrawing through fitting (11).
NOTE
Perform following steps only if re-
moval of compression sleeves (9),
n u t s ( 8 ) , f i t t i n g ( 1 1 ) , a n d e l b ow
(12) is necessary, otherwise proceed
to step (12) below.
(9) Remove compression sleeves (9)
and compression nuts (8).
(10) Remove fitting (11) using open
end wrench.
(11) Remove elbow (12) using open
end wrench.
(12) Tag fuel supply hose (2) then
loosen compression nut (13)
using open end wrench and
remove hose (2).
NOTE
Perform following steps only if com-
pression nut (13), sleeve (14), and
elbow (15) require removal.
(13) Remove compression sleeve (14)
then compression nut (13) from
fuel supply hose (2).
(14) Remove elbow (15).
4-11
