TM 5-3805-262-20
4-2. FUEL SYSTEM MAINTENANCE (CONT)
h. A c c e l e r a t o r ( c o n t ) .
INSTALLATION (SHEET 1 OF 2)
(1)
(2)
(3)
(4)
( 5)
(6)
(7)
(8)
(9)
Position brackets (50 and 51) and secure using two capscrews (47), lock
washers (49), and nuts (48).
Position accelerator pedal (42) on pivot bracket (51) then install pivot
pin (38) through pivot bracket (51) and accelerator pedal (42). Secure
pivot pin (38) using two retaining rings (37).
Install nut (45) and lock washer (46) on capscrew (44). Install capscrew
with assembled parts and loosely secure using washer (40) and lock nut
( 3 9 ).
Hook one end of spring (41) in accelerator pedal (42) hole and other end
of spring onto capscrew (44). Hand tighten lock nut (39).
Route accelerator cable between accelerator pedal (42) and fuel injection
pump.
Thread nut (36) and ball joint (35) completely onto threaded shaft of
accelerator cable. Connect ball joint (35) to accelerator pedal (42) and
secure using lock washer (34) and nut (33).
Position accelerator cable on cable bracket (50) and install clamp (32)
on accelerator cable . Secure clamp (32) using two capscrews (28), washers
(31), lock washers (30), and nuts (29). Tighten capscrews securely.
Position fuel shutoff cable between right instrument panel and fuel
injection pump.
Thread one nut (27) completely onto threaded shaft of fuel shutoff cable
and route threaded shaft through fuel shutoff control hole in instrument
panel. Secure using nut (27) and install handle (26) .
4-60
