TM 5-3805-262-20
INSTALLATION (SHEET 4 OF 4)
(12) At inside edge of bracket, position two circuit breakers (10) with long
terminal studs at top.
(13) Secure circuit breakers (10) to bracket using four capscrews (9), lock
washers (8), and nuts (7).
( 1 4 ) A t t o p c i r c u i t b r e a k e r ( 1 0)
, connect three wiring harness terminals (2)
to long terminal stud as tagged using lock nut (1).
(15) Connect one end of wire (3) to short terminal stud as tagged using lock
n u t ( l ) .
(16) At bottom circuit breaker (10), connect wire (6) terminal to long termi-
nal stud as tagged using lock nut (4).
(17) Connect wire (3 and 5) terminals to short terminal stud as tagged using
lock nut (4).
(18) Spray circuit breaker and relay terminals with electrical cleaner and
allow to air dry. Then spray terminals with electrical sealer.
( 1 9 ) I n s t a l l e n g i n e l e f t s i d e p a n e l s ( p a g e 9 - 1 7 ).
(20) Connect and tighten battery ground cable (page 5-151).
5-33
