TM 5-3805-262-20
INSTALLATION (SHEET 1 OF 2)
(1)
(2)
(3)
(4)
( 5)
(6)
(7)
( 8)
(9)
(10)
If necessary, install four clip nuts (30) in cab by pushing onto sheet
metal at locations noted during removal.
If removed,
install new filler strip (29) by removing protective paper
backing and pressing adhesive side of filler strip firmly onto top edge
of instrument panel (28).
Install instrument panel (28) in cab using
washers (27).
Install windshield washer valve at rear of
cure using nut (25).
four screws (26) and lock
instrument panel (28) and se-
Install and tighten knob (24) on windshield washer valve.
At rear of buzzer, connect two wiring harness terminals (22 and 23) to
buzzer as tagged using two screws (21).
At rear of voltmeter, connect wiring harness terminal (20) to IGN termi-
nal using nut (18) and lock washer (19).
Connect socket assembly (15) bullet terminal to wiring harness bullet
terminal (17) by grasping both in your fingers, alining, then firmly
pushing them together.
Install lamp (16) in socket assembly (15) by grasping lamp with fingers,
pushing lamp base into socket, and turning clockwise.
Install socket assembly (15) with lamp (16) in rear of voltmeter by
grasping socket with fingers, alining, and pushing firmly.
5-45
