TM 5-3805-262-205-4. INSTRUMENT PAN ELSMAINTENANCE (CONT)b. Right-hand Instrument Panel.This task covers removal, disassembly, cleaning,i n s p e c t i o n , t e s t i n g , a n d r e p a i r , r e a s s e m b l y , a n d i n s t a l l a t i o n o f r i g h t - h a n d i n s t r u-ment panel and its associated wiring .TOOLS: No. 1 Common Organizational Maintenance Tool KitCombination box and open end wrench setScrewdriverS l i p j o i n t p l i e rsHand hammer, 16 ouncesSocket wrench set, 3/8 inch driveE l e c t r i c a l r e p a i r t o o l k itMultimeterDrive pin punch, 1/8 inch pointPutty knifePaint brushSoldering gun, 25 wattsAir compressor equipped with pressure regulatorMATERIALS/PARTS: Clean cloths (Appendix C, item 1)Cleaning solvent P-D-680 (Appendix C, item 2)Detergent (Appendix C, item 3)Insulation tape (Appendix C, item 5)Isopropyl alcohol (Appendix C, item 15)Solder (Appendix C, item 16)Electrical cleaner (Appendix C, item 19)Electrical sealer (Appendix C, item 20)NOTEPRELIMINARY PROCEDURE: Battery ground cable disconnected (page 5-148).REMOVAL (SHEET 1 OF 2)(1)(2)(3)(4)(5)(6)(7)At bottom of air reservoir, open drain valve to relieve air pressure.In operator’s compartment, at right-hand instrument panel, push in andpull out knob of parking brake valve to relieve air pressure in parkingb r a k e c i r c u i t.Remove handle (1) by unscrewing from fuel shutoff cable (3).Remove nut (2) then pull fuel shutoff cable down from instrument panel.Remove roll pin (4) from knob (5) and parking brake valve stem using ham-mer and drive pin punch and pull knob (5) from valve stem.Loosen and remove nut (6) and lower parking brake valve from instrumentp a n e l.At wiring harness brown-red wire,separate fuseholder (7) halves bygrasping ends with fingers, pushing together, twisting counterclockwise,and pulling apart.5-48
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
