TM 5-3805-262-20REMOVAL(1)(2)(3)( 4)(5)(6)( 7)CLEANING(1)(2)DryIn battery compartment, at radiator guard, loosen and remove six screws( 1 ).Pull lens assembly (2) and gasket (3) from housing (9).Remove lamps (4) by pressing, turning 1/4 turn counterclockwise, andpulling from sockets.Disconnect wiring harness terminals (6) from light terminals (5) bygrasping with fingers and firmly pulling apart.Support housing (9), loosen and remove two capscrews (7) and lock washers(8), and remove housing (9) with socket assembly (11).Inside housing (9), loosen and remove three screws (10) and pull socketassembly (11) clear of housing (9) to facilitate inspection.Pry retaining rings (12) from screws (1) and remove from lens assembly(2) only if necessary for replacement .Clean lens assembly (2), gasket (3), lamps (4), socket assembly (11)rubber isolators, and wire insulation using clean cloth moistened withdetergent. Dry using clean cloth .Clean lamp (4) contacts, socket assembly (11) contacts, and wire termi-nals using clean cloth moistened with isopropyl alcohol.cleaning solvent P-D-680 used to clean parts is toxic and flammable.W e a r p r o t e c t i v e g o g g l e s a n d g l o v e s a n d u s e o n l y i n a w e l l v e n t i l a t eda r e a . A v o i d c o n t a c t w i t h s k i n , e y e s a n d c l o t h e s a n d d o n - t b r e a t hev a p o r s .Do not use near open flame or excessive heat and don’t smokewhen using it. Failure to do so could cause serious injury. If you be-c o m e d i z z y w h i l e u s i n g c l e a n i n g s o l v e n t , g e t f r e s h a i r a n d m e d i c ala t t e n t i o n i m m e d i a t e l y .If contact with skin or clothes is made, flushwith large amounts of water.I f c o n t a c t w i t h e y e s i s m a d e , w a s h e y eswith water and get medical aid immediately.(3) Clean all other metallic parts using clean cloth moistened with cleaningsolvent P-D-680. Dry using clean cloths.5-109
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
