CLEANING - TM-5-3805-262-20

TM-5-3805-262-20 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
556

TM 5-3805-262-20 5-7. LIGHT SYSTEMS MAINTENANCE (CONT) d. Stop and Tail Lights (cont). CLEANING (1) ( 2) Dry Clean lens (2), lamp cloth moistened with (3), housing (9), and wire insulation using clean detergent. Dry using clean cloth. Clean lamp (3) contacts and wire terminals using clean cloth moistened with isopropyl alcohol. cleaning solvent P-D-680 used to clean parts is toxic and flammable. W e a r p r o t e c t i v e g o g g l e s a n d g l o v e s a n d u s e o n l y i n a w e l l v e n t i l a t ed a r e a . A v o i d c o n t a c t w i t h s k i n , e y e s a n d c l o t h e s a n d d o n ’ t b r e a t h e vapors . Do not use near open flame or excessive heat and don’t smoke when using it. Failure to do so could cause serious injury. If you be- c o m e d i z z y w h i l e u s i n g c l e a n i n g s o l v e n t , g e t f r e s h a i r a n d m e d i c al a t t e n t i o n i m m e d i a t e l y . If contact with skin or clothes is made, flush w i th with (3) INSPECTION (1) (2) (3) ( 4 ) large amounts of water. I f c o n t a c t w i t h e y e s i s m a d e , w a s h e y es water and get medical aid immediately. Clean all other metallic parts using clean cloth moistened with cleaning solvent P-D-680. Dry using clean cloths. AND REPAIR Inspect terminal (4 and 5) wires for cracked or broken insulation or broken wire strands at connection to terminal. Repair cracked or broken insulation by applying insulation tape to area. If broken wire strands are seen, cut wire as close to terminal as possible. Strip 1/4 inch insu- lation from end of wire taking care not to cut through wire then crimp new terminal securely onto wire. Inspect housing (9) for cracks, breaks, damaged threads, distortion, broken wires at housing, or other damage. Replace stop and tail light as an assembly if any of the above conditions are seen. Inspect lamp (3) for cracked or broken glass or corroded base. Connect multimeter between lamp base and center contact and check for continuity. Replace lamp if any of the above conditions are seen or multimeter does n o t i n d i c a t e c o n t i n u i t y . Inspect remaining parts for cracks, breaks, distortion, or damaged threads; replace as necessary. 5-106

Privacy Statement
Press Release
Contact