TM 5-3805-262-20
INSTALLATION
( 1)
(2)
( 3 )
Position cover plate (6) and one end of wire (11) on fuel level sending
unit (12) as noted during removal. Then secure with five lock nuts (10),
washers (9), and screws (8).
At right side of fuel tank, aline holes in new gasket (7) with holes in
f u e l t a n k.
Carefully install cover plate (6) with wire (11) and fuel level sending
unit (12); be sure you position float and rod in fuel tank as noted
during removal.
(4)
(5)
(6)
(7)
Position remaining end of wire (11) at cover plate (6) as noted during
removal. Then install and tighten five capscrews (4) and lock washers
( 5 ).
Connect terminal (3) to fuel level sending unit (12) and secure using
lock washer (2) and nut (l).
Spray wire (11) terminals and terminal (3) with electrical cleaner and
allow to air dry.
Then spray terminals with electrical sealer.
I n s t a l l e n g i n e l e f t r e a r s i d e p a n e l ( p a g e 9 - 1 7 ).
5-119