TM 5-3805-262-202-8. PREPARATION FOR AIR TRANSPORT (CONT)a. Preparation Prior to Cab Removal.(1) Start engine and raise bucket one foot off ground using LIFT ARM control(2)lever in RAISE position then return to NEUT. position.Using BUCKET control lever in CROWD position, rollback bucket completelythen return BUCKET control lever to NEUT. position.(3)(4)(5)Secure bucket assembly in rollback position using 12 foot length of chainwith a hook on each end. Position one chain hook on center bucket toothand lift arm brace as shown above.Install transport bracket, stored in tool box located in cab, on eitherlift cylinder assembly rod and secure using capscrew and nut.Turn off engine.When performing following step, be sure that engine is off. Failure todo so will cause damage to transport bracket and lift cylinder assembly,and may distort bucket lift arms.(6) Place LIFT ARM control lever in LOWER position and slowly lower bucket.Lift cylinder assembly rod will retract and bucket will lower until rodeye is resting on transport bracket.(7) Remove cab (step b below).b. CabRemoval.(1) At rear of cab, just behind heater console, disconnect cab console wiringharness connector from cab upper wiring harness connector. Do this bydisengaging wiring harness connector tabs from ears of cab upper wiringharness connector. After tabs are disengaged from ears, grasp wiring har-ness connector body and firmly pull from mating connector.2-14
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business