TM 5-3805-262-20
NOTE
It isnt necessary to remove hardware securing opposite end of ground
s t r a p ( 1 7 ) t o f r o n t c h a s s i s t o r e m o v e g r o u n d s t r a p . P o s i t i o n g r o u nd
strap out of the way.
(8) Connect chain hoist hooks to lifting eyes at top of cab and take up all
s l a c k.
When performing following step, warn personnel not to place any part of
their body between cab and frame of loader. To do so could cause death
o r s e r i o u s i n j u r y d u e t o c a b s w i n g i n g a n d s t r i k i n g p e r s o n n e l . U s e
e x t r e m e c a u t i o n t o p r e v e n t i n j u r y t o p e r s o n n e l . I f p e r s o n n e l a r e i n-
jured, obtain medical aid immediately.
When using chain hoist to remove or install parts, be sure chain hoist
i s s e c u r e l y f a s t e n e d t o t h e p a r t a n d t h a t a l l s l a c k i n c h a i n i s t a k e n
up, Failure to do so could cause death or serious injury due to the part
falling on you.
If you are injured by falling equipment, obtain medical
aid immediately.
Before raising cab, check and ensure that all
e l e c t r i c a l l e a d s h a v e b e e n d i s c o n n e c t e d ,
attaching hardware has been removed, and that
w i r i n g h a r n e s s c o n n e c t o r h a s
d i s c o n n e c t e d . F a i l u r e t o d o s o c o u ld
damage to equipment.
(9)
( l 0 )
Slowly raise cab off front chassis
deck while an assistant guides cab
to ensure that it does not strike
steering wheel or swing rearward
s t r i k i n g o i l c o o l e r g r i l l.
Remove cab from loader front chas-
s i s a n d p o s i t i o n o n p a l l e t . If
possible, place all removed parts
in tool box at rear of cab. If a
part cannot be placed in tool box,
secure to cab using suitable means
to prevent loss.
b e e n
c a u s e
NOTE
To comply with the maximum transportation height restrictions,
and/or to minimize possible damage to the ROPS cab, the cab can
be removed from the Loader and transported separately.
A custom pallet can be constructed to bold the cab as shown on page 2-24.
2-17