TM 5-3805-262-20
SERVICING (SHEET 2 OF 2)
(b)
Remove battery cell caps by turning counterclockwise. Rinse in clear
water and dry using clean cloth. Inspect cell caps for clogged vent
holes. Clear clogged vent holes using a thin, stiff wire.
( c)
Inspect battery cases and covers for cracks, leakage, or other damage.
Inspect battery posts for damage. If any of the above conditions are
seen, replace battery (page 5-148).
Do not add electrolyte when servicing batteries. Add distilled water or
o t h e r c l e a n w a t e r o n l y . Do not fill above level of ring at bottom of
cell opening.
(d)
I n s p e c t e l e c t r o l y t e l e v e l i n e a c h b a t t e r y c e l l . I f n e c e s s a r y , a d d d i s -
t i l l e d w a t e r t o e a c h c e l l u n t i l e l e c t r o l y t e l e v e l i s e v e n w i t h r i n g at
bottom of cell opening.
(e)
Install battery cell caps by turning clockwise.
( f )
C l o s e r a d i a t o r g r i l l e.
(g)
If temperature is 32 degrees F or below, start engine and run for 1 to
2 hours to mix water with electrolyte and prevent water from freezing.
5-141
