TM 5-3805-262-20
INSTALLATION (SHEET 2 OF 2)
(h)
Install two J-bolts (10) and bracket (9).
( i )
At left end of bracket (9), position clamp (8) with positive cable on
threaded end of J-bolt (10).
D O not overtighten nuts (6) in following step. Excessive tightening can
damage battery cases.
( j )
Install and tighten two lock washers (7) and nuts (6).
(k)
Install cable (5) terminals on battery posts and tighten terminal
n u t s .
( l )
A t r e a r b a t t e r y , i n s t a l l t e r m i n a l ( 4 ) w i t h p o s i t i v e c a b l e s o n b a t t e ry
post and tighten nut (3).
(m)
At front battery, install terminal (2) with battery ground cables on
b a t t e r y p o s t a n d t i g h t e n n u t ( l ).
(n)
Spray battery cable terminals with electrical cleaner and allow to air
dry. Then spray terminals with electrical sealer.
(o)
C l o s e r a d i a t o r g r i l l e.
5-153
