TM 5-3805-262-205-9 BATTERIES AND CABLES MAINTENANCE (CONT) c. B a t t e r y C a b l e s .This task covers removal, cleaning, inspection, and installa-tion of battery cables.TOOLS: No. 1 Common Organizational Maintenance Tool KitCombination box and open end wrench setTorque wrench, 1/2 inch driveScratch wire brushB a t t e r y t e r m i n a l l i f t erAutomotive Mechanic’s Tool KitSocket wrench set, 1/2 inch driveMATERIALS/PARTS: Clean cloths (Appendix C, item 1)Cleaning solvent P-D-680 (Appendix C, item 2)Detergent (Appendix C, item 3)Insulation tape (Appendix C, item 5)Electrical cleaner (Appendix C, item 19)Electrical sealer (Appendix C, item 20)Tie strap (AR) (FSCM 53421 PN T50R0W)NOTEPRELIMINARY PROCEDURE: Engine left side panels removed (page 9-14) andr a d i a t o r g r i l l e o p e n.REMOVAL (SHEET 1 OF 2)I n f o l l o w i n g s t e p s r e m o v e t e r m i n a l s f r o m b a t t e r y p o s t s u s i n g b a t t e ryt e r m i n a l l i f t e r .To prevent damage to batteries, do not pry terminalsloose using screwdriver .(l.)(2)(3)( 4)( 5)(6)(7)5-158Inside battery compartment, at front battery, loosen nut (1) and pullterminal (2) with ground cables from battery post. Push terminal (2)aside to prevent contact with battery post.At rear battery, loosen nut (3) and pull terminal (4) with positivecables from battery post.At cable (5), loosen two terminal nuts and pull terminalsposts. Remove cable (5) from loader.Loosen and remove nut (6), cables (7 and 8), and capscrewn a l ( 4 ) .from battery(9) from termi-Loosen and remove nut (10), cables (11 and 12), and capscrew (13) fromt e r m i n a l ( l ) .Behind left stop light, at slave receptacle, loosen and remove two cap-screws (14) and lock washers (15) and disconnect cables (7 and 11).Cut and remove tie strap (16) and remove cables (7 and 11) from loader.D i s c a r d t i e s t r a p.
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business