TM 5-3805-262-202-8. PREPARATION FOR AIR TRANSPORT (CONT)e. C a b I n s t a l l a t i o n ( C o n t ).(5)(6)(7)(8)( 9)(10)A t r i g h t , r e armounting hole.side, near bottom of cab, start capscrew (18) through itsInstall lock washer (19) then ground strap (20) on cap-screw. If necessary, use pry bar to move cab to get enough room betweencab and chassis to install these parts and to aline holes. Completely in -stall capscrew (18) and secure using lock washer (17) and nut (16).Tighten securely.At rear of cab,install two washers (15), lock washers (14), and cap-screws (13). If necessary, use pry bar or chain hoist to aline mountingh o l e s .At front center of cab, near steering wheel, raise windshield wiper motorbracket to gain access to cab center mounting hole. Install washer (12),lock washer (11), and capscrew (10).At four corners of cab, install four mounting spacers (9), washers (8),and capscrews (7); at chassis bottom install washers (6), and nuts (5).Tighten capscrew (10) and four capscrews (7) to 240 - 280 lb-ft. Tightentwo capscrews (13) to 45 - 55 lb-ft.Disconnect chain hoist from cab.2-20
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business