TM 5-3805-262-20
REMOVAL
(1)
(2)
( 3)
(4)
(5)
(6)
(7)
( 8)
(9)
(10)
CLEANING
Place one quart container under elbow (6) to catch any oil that may drain
from hose (5) when disconnected from elbow.
Loosen elbow (6) just enough to enable removal of sampling valve (1),
then remove sampling valve (l), pipe nipple (2), and plate (3).
Tag hose (5) then loosen nut (4) and disconnect hose (5) from elbow (6).
Remove elbow (6) and 0-ring (7).
Tag hose (9) then loosen nut (8) and disconnect hose (9) from connector
( 1 0 ) .
Remove connector (10) and 0-ring (11).
At rear of vehicle, position two gallon container under radiator to catch
any oil that may drain from hoses (5 and 9) when disconnected.
At bottom of radiator, loosen nut (12) then disconnect and remove hose
(5) from vehicle.
Remove elbow (13).
Loosen nut (14) then disconnect and remove hose (9) from vehicle. Remove
elbow (15).
Compressed air used for cleaning purposes will not exceed 30 psi. Use
o n l y w i t h e f f e c t i v e c h i p g u a r d i n g a n d p e r s o n a l p r o t e c t i v e e q u i p m e nt
( g o g g l e s / s h i e l d , g l o v e s , e t c ).
F a i l u r e t o d o s o c o u l d c a u s e s e r i o u s
i n j u r y t o e y e s a n d p o s s i b l e b l i n d n e s s.
If you hurt your eyes or if a
f o r e i g n o b j e c t i s b l o w n i n t o y o u r e y e s , s e e k m e d i c a l a t t e n t i o n
immediately.
(1) Clean and flush interior of hoses (5 and 9) using clean hydraulic oil and
compressed air. Dry exterior of hoses with clean cloth .
Dry cleaning solvent P-D-680 used to clean parts is toxic and flammable.
W e a r p r o t e c t i v e g o g g l e s a n d g l o v e s a n d u s e o n l y i n a w e l l v e n t i l a t ed
a r e a . A v o i d c o n t a c t w i t h s k i n , e y e s a n d c l o t h e s a n d d o n ’ t b r e a t he
v a p o r s,
Do not use near open flame or excessive heat and don’t smoke
w h e n u s i n g i t . F a i l u r e t o d o s o c o u l d c a u s e s e r i o u s i n j u r y . I f y ou
b e c o m e d i z z y w h i l e u s i n g c l e a n i n g s o l v e n t , g e t f r e s h a i r a n d m e d i c a l
attention immediately. I f c o n t a c t w i t h s k i n o r c l o t h e s i s m a d e , f l u s h
w i t h
w i t h
l a r g e a m o u n t s o f w a t e r . I f c o n t a c t w i t h e y e s i s m a d e , w a s h e y es
water and get medical aid immediately.
(2)
Using clean cloth moistened with cleaning solvent P-D-680, clean remain-
ing parts; dry using clean cloth.
6-27
