TM 5-3805-262-206-1. TRANSMISSION MAINTENANCE (CONT)c. Transmission Pump andOilFilterandLines(cont).(2) Oil Filter and Lines (cont).CLEANING (SHEET 2 OF 2)Compressed air used for cleaning purposes will not exceed 30 psi. Useo n l y w i t h e f f e c t i v e c h i p g u a r d i n g a n d p e r s o n a l p r o t e c t i v e e q u i p m e nt( g o g g l e s / s h i e l d , g l o v e s,e t c ) . F a i l u r e t o d o s o c o u l d c a u s e s e r i o u si n j u r y t o e y e s a n d p o s s i b l e b l i n d n e s s.If you hurt your eyes or if af o r e i g n o b j e c t i s b l o w n i n t o y o u r e y e s , s e e k m e d i c a l a t t e n t i o nimmediately.(b) Flush inside of supply and return tubes (3 and 7) with cleaning solventP-D-680. Dry using compressed air.INSPECTIONNOTEIn following steps, replace parts determined to be defective.(a) Inspect return tube (3) and supply tube (7) for kinks, dents, or cracks .Check compression nuts (2 and 6) for crossed or damaged threads.( b ) I n s p e c t O - r i n g s ( 5, 9 , a n d 1 1 ) f o r c r a c k s , l o s s o f e l a s t i c i t y , o r d e f o r-mation.(c) Inspect adapters (4 and 8) and elbow (10) for cracks, deformation, ordamaged or stripped threads.(d) Inspect filter head (15) for cracks or stripped or damaged threads.(e) Inspect remaining parts for cracks, bent condition, or damaged or strip-ped threads.INSTALLATION (SHEET 1 OF 2)(a) Position mounting bracket (19) on transmission; secure using two lockwashers (18) and capscrews (17); tighten securely.(b) Position spacer (16) and filter head (15) on mounting bracket (19); se-cure using four washers (14), lock washers (13) and capscrews (12).(c) Install O-ring (11) and elbow (10) in filter head (15).( d ) I n s t a l l O - r i n g ( 9 ) a n d a d a p t e r ( 8 ) i n t r a n s m i s s i o n p o r t .(e) Route supply tube (7) between adapter (8) and elbow (10) and connect andtighten two compression nuts (6) securely.6-24
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business