TM 5-3805-262-208-2. STEERING SYSTEM MAINTENANCE (CONT) b. H o s e s , L i n e s,a n d F i t t i n g s ( c o n t ) .(2) Replacement.This task covers removal, cleaning, inspection, and installa-t i o n o f s t e e r i n g s y s t e m h o s e s , l i n e s , a n d f i t t i n g s .TOOLS: No. 1 Common Organizational Maintenance Tool KitSocket wrench set, 3/8 inch driveFixed open end wrench setMultimeterPlugMATERIALS/PARTS: Clean cloths (Appendix C, item 1)Cleaning solvent P-D-680 (Appendix C, item 2)Detergent (Appendix C, item 3)Hydraulic oil (Appendix C, item 13)0-rings, seven (FSCM 10988 PN 218-5007)0-rings, four (FSCM 10988 PN 218-5006)0-ring (FSCM 10988 PN 218-5008)0-rings, two (FSCM 10988 PN 218-5010)NOTEPRELIMINARY PROCEDURE: Engine left side panels removed (page 9-14) andhydraulic oil drained from hydraulic reservoir (page 11-79) .REMOVAL (SHEET 1 OF 5)( a ) A b o v e h y d r a u l i c r e s e r v o i r , a t s t e e r i n g g e a r , tag, loosen, and disconnecthose (1) fitting at steering gear. Loosen then disconnect fitting onother end of hose (1) at flow control valve and remove hose from loader.(b) Remove and discard O-ring (2).(c) Tag, loosen, and disconnect hose (3) fitting at steering gear. Loosenthen disconnect fitting on other end of hose (3) at tee (9) installed inflow control valve port. Remove hose (3) from loader.(d) Tag, loosen, and disconnect hose (4) fitting at elbow (15) installed insteering gear port. Don’t disconnect fitting on other end of hose (4)y e t.(e) Tag, loosen, and disconnect hose (5) fitting connected to tee (9) in-stalled in flow control valve port. Don't disconnect fitting on otherend of hose (5) yet.(f) Tag hose (6). Loosen tube (7) fitting securing hose (6) then disconnecthose from tube. Loosen and disconnect fitting on other end of hose (6)from flow control valve port.(g) Remove hose (6) from loader.8-14
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business