TM 5-3805-262-208-2. STEERING SYSTEM MAINTENANCE (CONT)d. H y d r a u l i c O i l C o o l e r ( c o n t ).INSTALLATION ( SHEET 2 OF 3)(2)(3)(4)(5)(6)(7)While an assistant supports hydraulic oil cooler (14), position coolergrille (13) on front of hood support and secure using four capscrews (8),washers (12 and 11), lock washers (10), and nuts (9). Tighten capscrews(8) and nuts (9) securely.Position and connect tube (6) fittings to elbow installed in steeringhydraulic filter head and elbow (7). Tighten tube fittings.On right side of loader, atbottom of hydraulic oil cooler(14) , install flow switch (4)and connector (2).Connect three terminals (3) towiring harness leads by pushingterminals (3) into wiring har-ness terminals.Remove plug from hose (1)fitting and connect hosef i t t i n g t o c o n n e c t o r ( 2 );t i g h t e n h o s e f i t t i n g s e c u r e l y .Connect heater hose (30, page10-38) to engine (page 10-43).8-38
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business