TM 5-3805-262-20
INSTALLATION (SHEET 3 OF 3)
(8) If vacuum pump is used, turn off vacuum pump, and disconnect from
hydraulic reservoir fill cap opening. Go to step (10) below.
(9) If vacuum pump is not used,
f i l l h y d r a u l i c r e s e r v o i r w i t h o i l ( p a ge
11-79) .
( 1 0 ) T i g h t e n h y d r a u l i c r e s e r v o i r f i l l c a p .
( 1 1 ) S t a r t e n g i ne
Before performing
and operate at idle speed.
following step, warn personnel to stay away from sides
o f l o a d e r b e t w e e n f r o n t a n d ‘ r e a r c h a s s i s . F a i l u r e t o d o s o w i l l c a u se
death or serious injury to those personnel due to chassis pivoting and
c r u s h i n g t h e m.
I f p e r s o n n e l a r e i n j u r e d , o b t a i n m e d i c a l a s s i s t a n c e
immediately.
( 1 2 ) W a i t o n e m i n u t e t h e n t u r n s t e e r i n g w h e e l a l l t h e w a y t o t h e r i g h t t h e n
all the way to the left to bleed any air from hydraulic system.
(13) Turn off engine and check for oil leaks. Tighten fittings as necessary.
( 1 4 ) R e i n s t a l l e n g i n e l e f t a n d r i g h t s i d e p a n e l s ( p a g e 9 - 1 7 ) a n d e n g i n e t o p
hood (page 9-13).
8 - 3 9
