TM 5-3805-262-20
8-2. STEERING SYSTEM MAINTENANCE (CONT)
d. Hydraulic Oil Cooler (cont).
REMOVAL (SHEET 3 OF 3)
(8)
On left side of loader, at bottom of hydraulic oil cooler (14), loosen
tube (6) fitting and remove tube from loader.
Be careful when performing following steps not to drop hydraulic oil
cooler (14). To do so will damage cooling fins.
(9)
While an assistant supports hydraulic oil cooler (14), remove four
capscrews (8), nuts (9), lock washers (10), and washers (11 and 12).
(10) Remove cooler grille (13) and hydraulic oil cooler (14) from loader.
(11) Remove elbows (5 and 7) from hydraulic oil cooler (14).
CLEANING
Compressed
o n l y w i th
a i r u s e d f o r c l e a n i n g p u r p o s e s w i l l n o t e x c e e d 3 0 p s i . U se
e f f e c t i v e c h i p g u a r d i n g a n d p e r s o n a l p r o t e c t i v e e q u i p m e nt
( g o g g l e s / s h i e l d , g l o v e s , e t c ).
F a i l u r e t o d o s o c o u l d c a u s e s e r i o us
i n j u r y t o e y e s a n d p o s s i b l e b l i n d n e s s.
If you hurt your eyes or if a
f o r e i g n o b j e c t i s b l o w n i n t o y o u r e y e s , s e e k m e d i c a l a t t e n t i o n
immediately.
(1)
Clean hydraulic oil cooler (14) by back flushing with clean hydraulic oil
and compressed air until all foreign matter is removed.
Dry cleaning solvent P-D-680 used to clean parts is toxic and flammable.
W e a r p r o t e c t i v e g o g g l e s a n d g l o v e s a n d u s e o n l y i n a
a r e a . A v o i d c o n t a c t w i t h s k i n , e y e s a n d c l o t h e s a n d
v a p o r s . D o n o t u s e n e a r o p e n f l a m e o r e x c e s s i v e h e at
w h e n u s i n g i t . F a i l u r e t o d o s o c o u l d c a u s e s e r i o u s
b e c o m e d i z z y w h i l e u s i n g c l e a n i n g s o l v e n t , g e t f r e s h
attention immediately. I f c o n t a c t w i t h s k i n o r c l o t h e s
w i t h
w i th
(2)
l a r g e a m o u n t s o f w a t e r . I f c o n t a c t w i t h e y e s is
water and get medical aid immediately.
Clean remaining metallic parts by wiping with clean
cleaning solvent P-D-680. Dry using clean cloth.
w e l l v e n t i l a t e d
d o n ’ t b r e a t h e
and don-t smoke
i n j u r y . I f y o u
air and medical
i s m a d e , f l u s h
made, wash eyes
cloth moistened with
8-36
