TM 5-3805-262-20
INSTALLATION ( SHEET 2
( j )
(k)
( l )
(m)
(n)
If vacuum
h y d r a u l ic
OF 2)
pump is not used, fill
r e s e r v o i r w i t h o il
(page 11-79).
T i g h t e n h y d r a u l i c r e s e r v o i r f i ll
cap (1).
Start engine and operate at idle
speed for two minutes then in-
crease engine speed to full
throttle for two minutes.
Pull out fuel SHUT OFF control to
stop engine but keep ignition key
switch in RUN position.
Check that auxiliary steering
pump and motor is operating; if
i t i s n o t o p e r a t i n g , g o t o t r o u-
bleshooting (page 3-137) .
Before performing following step, warn personnel to stay away from sides
o f l o a d e r b e t w e e n f r o n t a n d r e a r c h a s s i s . F a i l u r e t o d o s o w i l l c a u se
death or serious injury to those personnel due to chassis pivoting and
c r u s h i n g t h e m .
I f p e r s o n n e l a r e i n j u r e d , o b t a i n m e d i c a l a s s i s t a n c e
immediately.
(o) Wait one minute then turn steering wheel all the way to the right then
all the way to the left to bleed air from system.
(p) Set ignition key switch to OFF position.
( q ) C h e c k f o r o i l l e a k a g e a t a u x i l i a r y s t e e r i n g p u m p a n d m o t o r . T i g h t en
f i t t i n g s a s n e c e s s a r y.
8-33
