TM 5-3805-262-20
8-2. STEERING SYSTEM MAINTENANCE (CONT)
e. S t e e r i n g H y d r a u l i c F i l t e r ( c o n t ) .
(2)
CLEANING
Removal (cont).
AND INSPECTION
Dry cleaning solvent P-D-680 used to clean parts is toxic and flammable.
W e a r p r o t e c t i v e g o g g l e s a n d g l o v e s a n d u s e o n l y i n a w e l l v e n t i l a t ed
a r e a . A v o i d c o n t a c t w i t h s k i n ,
e y e s a n d c l o t h e s a n d d o n ’ t b r e a t he
vapors. Do not use near open flame or excessive heat and don-t smoke
w h e n u s i n g i t . F a i l u r e t o d o s o c o u l d c a u s e s e r i o u s i n j u r y . I f y o u
b e c o m e d i z z y w h i l e u s i n g c l e a n i n g s o l v e n t , g e t f r e s h a i r a n d m e d i c a l
a t t e n t i o n i m m e d i a t e l y . I f c o n t a c t w i t h s k i n o r c l o t h e s i s m a d e , f l u sh
w i t h l a r g e a m o u n t s o f w a t e r .
If contact with eyes is made, wash eyes
with water and get medical aid immediately.
(a) Clean all parts using cleaning solvent P-D-680. Dry using clean cloths.
(b) Inspect elbows (5 and 8) and filter head (13) for cracks, breaks, defor-
mation, damaged or stripped threads, or other damage. Replace as neces-
s a r y.
(c) Check mounting bracket (18) for bent condition, cracks, or breaks. Re-
place as necessary.
(d) Check restriction switch (20) for loose or damaged terminal. Replace as
necessary. Connect multimeter between restriction switch terminal and
clean metal surface of body. Multimeter shall indicate no continuity. If
continuity is indicated on multimeter, replace restriction switch.
(e) Inspect remaining parts for cracks, breaks, deformation, or damaged
threads. Replace as necessary.
INSTALLATION (SHEET 1 OF 3)
( a ) I n s t a l l n e w 0 - r i n g s ( 2 1 a n d 2 2 ) o n r e s t r i c t i on
switch (20).
( b ) I n s t a l l r e s t r i c t i o n s w i t c h ( 2 0 ) i n f i l t e r
head.
( c ) I n s t a l l a n d t i g h t e n n u t ( 1 9 ) o n r e s t r i c t i on
switch (20) terminal.
(d) Position mounting bracket (18) on engine
right side hood. Secure using four cap-
screws (14), eight washers (17), four lock
washers (16), and nuts (15). Tighten nuts
and capscrews securely.
8-44
