TM 5-3805-262-344-3. TRANSMISSION MAINTENANCE (CONT)b. TorqueConverterHousing (Cont).REMOVAL (SHEET 3 OF 3)When using chain hoist to remove or install parts, be sure chain hoistis securely fastened to the part and that all slack in chain is takenup. Failure to do so could cause serious injury due to the part fallingon you. If you are injured by falling equipment, obtain medical aidimmediately.(4)(5)(6)Remove torque converter housing(20) and assembled parts (5through 19) from transmissionhousing.Remove drive gear and shaftassembly (23) and assembled parts(21 and 22) from transmissionhousing.Using two pry bars as shown, re-move drive gear and shaft assem-bly (29) and assembled parts (24thru 28) from transmission hous-ing.(7) Remove and discard gasket (30).DISASSEMBLY (SHEET 1 OF 3)(1)Remove retaining ring (7) from driven gear (5) using retaining ringpliers.(2)Using soft hammer, tap shaft of driven gear (5) to push bearing (8) fromtorque converter housing (20). Remove driven gear (5) and bearings (6 and(3) Put driven gear (5) in hydraulic press with collar positioned as shown.Press driven gear from bearing (6).4-116
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business