TM 5-3805-262-34
4-3. TRANSMISSION MAINTENANCE (CONT)
b. Torque Converter Housing. This task covers removal, disassembly, cleaning,
inspection, reassembly, and installation of torque converter housing.
TOOLS: No. 1 Common Organizational Maintenance Tool Kit
Socket head screw key set
Retaining ring pliers
Safety glasses
Torque wrench, 1/2 inch drive
Mechanical puller kit
Vise
Vise jaw caps
Hand hammer, 16 ounces
Automotive Mechanic-s Tool Kit
Socket wrench set, 1/2 inch drive
Hand hammer, 8 ounces
Putty knife
Drive pin punch, 1/4 inch point
Pry bars, two
Slip joint pliers
Machinist’s steel rule
Wood blocks, two, 2 by 4 by 8 inches
Heat resistant gloves
Hydraulic press
Sleeve, 2 inches outside diameter
Sleeve, 2-1/4 inches inside diameter by 9 inches long
Sleeve, 3-3/8 inches outside diameter
Sleeve, 3-1/2 inches inside diameter
Bearing collar remover
Oven
Micrometer, zero to 5 inches
Spring gage
Chain hoist
Studs , two, 5/16-18 by 4 inches long
Dry ice
MATERIALS/PARTS: Clean cloths (Appendix C, item 1)
Cleaning solvent P-D-680 (Appendix C, item 2)
Thread sealant (Appendix C, item 14)
Lubricating oil (Appendix C, item 15)
Oil-soluble grease (Appendix C, item 26)
Transmission gasket kit (FSCM 73342 PN 6838897)
NOTE
PRELIMINARY PROCEDURE: Torque converter group removed (page 4-94).
REMOVAL (SHEET 1 OF 3)
(1)
Remove 23 capscrews (1), capscrew (2), 24 lock washers (3), and washers
(4) from torque converter housing (20).
4-112
