TM 5-3805-262-344-3. TRANSMISSION MAINTENANCE (CONT)b. Torque Converter Housing (Cont).REASSEMBLY(1)(2)(3)(4)(5)(6)If(SHEET 1 OF 4)Put drive gear and shaft (29)in hydraulic press. Positionbearing (28) on drive gear andshaft and press bearing ontodrive gear and shaft using2-1/4 inches inside diametersleeve.Lubricate new seal (24) usinglubricating oil and install ingroove in hub of drive gear andshaft (29).Install thrust race (27), thrust bearing (26),drive gear and shaft (29).Put bearing (22) in hydraulicpress using a 2-1/4 inchesinside diameter by 9 incheslong sleeve to support it. Putdrive gear and shaft (23) inbearing and sleeve. Press driveand thrust race (25) ongear and shaft into bearing.Lubricate new seal (21) usinglubricating oil. Install sealin groove on hub of drive gearand shaft (23).If removed, position valve (18)and converter pressure regula-tor spring (19) on valve guidepin (16). Press valve guide pininto upper torque converterhousing valve bore until valveguide pin protrudes 1.16 to1.18 inches above surface ofvalve (18).NOTEpress fit of valve guide pin (16) is not satisfactory, clean andapply thread sealant to bore and valve guide pin. Allow thread sealantto cure for two hours at room temperature after pressing valve guide pininto bore.4-124
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business