TM 5-3805-262-344-3. TRANSMISSION MAINTENANCE (CONT)b. TorqueConverterHousing (Cont).CLEANINGDry cleaning solvent P-D-680 used to clean parts is toxic and flammable.Wear protective goggles and gloves and use only in a well ventilatedarea. Avoid contact with skin, eyes and clothes and don-t breathevapors. Do not use near open flame or excessive heat and don-t smokewhen using it. Failure to do so could cause serious injury. If you be-come dizzy while using cleaning solvent, get fresh air and medicalattentionwith largewith waterCompressedonly withimmediately.If contact with skin or clothes is made, flushamounts of water. If contact with eyes is made, wash eyesand get medical aid immediately.air used for cleaning purposes will not exceed 30 psi. Useeffective chip guarding and personal protective equipment(goggles/shield, gloves, etc). Failure to do so could cause seriousinjury to eyes and possible blindness.If you hurt your eyes or if aforeign object is blown into your eyes, seek medical attentionimmediately.(1)(2)(3)Clean bearings (6, 8, 22, and 28) by immersing in cleaning solvent P-D-680 and slowly moving up and down. Remove bearings from cleaning solventand strike larger side of cone against a block of wood to dislodgesolidified particles of lubricant. Immerse again in cleaning solvent andrepeat above until bearings are clean. Dry using compressed air. Directair stream across bearing to avoid spinning. Don-t spin bearings whendrying; rotate bearings slowly by hand to facilitate drying. After dryingbearings, lubricate using clean lubricating oil. Keep bearings in a cleanarea.Clean remaining partspressed air.Clean all gasket (30)transmission housing.P-D-680.using cleaning solvent P-D-680. Dry using com-material from torque converter housing (20) andUse clean cloth moistened with cleaning solvent4-122
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
