TM 5-3805-262-34
4-3. TRANSMISSION MAINTENANCE (CONT)
b. Torque Converter Housing (Cont).
INSTALLATION (SHEET 2 OF 2)
(6)
(7)
(8)
(9)
(10)
(11)
Slowly lower torque
past drive gear and
converter housing (20) guiding driven gear (5) shaft
shaft (23).
Continue lowering torque converter housing (20) while guiding dowel pins
in housing into alinement with holes in transmission housing until torque
converter housing is resting on transmission housing.
Disconnect chain hoist from torque converter housing (20).
Start eight washers (4), lock washers (3), and capscrews (1) into trans-
mission housing. Install capscrews on each side of dowel pins and evenly
on each side of housing. Tighten capscrews evenly to pull torque convert-
er housing against transmission housing.
Install remaining washers (4), lock washers (3), capscrew (2), and cap-
screws (1). Tighten every other capscrew (1 and 2) to 42 to 50 lb-ft
until all capscrews are tight.
Install torque converter group (page 4-108).
4-132
