TM 5-3805-262-34
4-3. TRANSMISSION MAINTENANCE (CONT)
c. Transmission Turbine Driven Gears and Freewheel Unit (Cont).
REMOVAL (SHEET 2 OF 2)
(3) Remove front cover (19) and
gasket (20). If necessary, use
hammer and pry bar to loosen
cover. Discard gasket (20).
(4)
Remove seal (21) from front
cover (19). Discard seal.
(5) If necessary, remove plug (22).
DISASSEMBLY (SHEET 1 OF 2)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
4-136
Put freewheel unit in hydraulic press
as shown. Press freewheel unit from
first turbine driven gear (1).
Remove bearing (4) and bearing spacer
(3) from first turbine driven gear
(1). Bearing and spacer will be lay-
ing on top of first turbine driven
gear after freewheel unit is pressed
from gear.
Turn first turbine driven gear (1)
over and put on hydraulic press.
Using 2-3/4 inches outside diameter
rod, press bearing (4) from first
turbine driven gear (1).
Remove bearing spacer (2) from second
turbine driven gear (16) shaft.
Remove 15 rollers (5) from
roller cage (8).
Remove 12 lock nuts (6) from
capscrews (12).
Using screwdriver, pry free-
wheel cam (7) from second tur-
bine driven gear (16).
Remove second turbine driven
gear (16) from freewheel cam
(7), roller cage (8), and
spring retainer plate (9).
