TM 5-3805-262-34
4-3. TRANSMISSION MAINTENANCE (CONT)
c. Transmission Turbine Driven Gears and Freewheel Unit.
This task covers re-
moval, disassembly, cleaning, inspection, reassembly, and installation of transmis-
sion turbine driven gears and freewheel unit.
TOOLS: No. 1 Common Organizational Maintenance Tool Kit
Socket head screw key set
Safety glasses
Screwdriver
Torque wrench, 1/2 inch drive
Fixed open end wrench set
Vise jaw caps
Vise
Hand hammer, 16 ounces
Drill bit, 1/8 inch
Drill, 1/2 inch capacity
Automotive Mechanic's Tool Kit
Socket wrench set, 1/2 inch drive
Putty knife
Slip joint pliers
Pry bars, two
Wood blocks, two, 2 by 4 by 8 inches
Hydraulic press
Rod, 2-3/4 inches outside diameter
Sleeve, 1-1/2 inches inside diameter by 8 inches long
Spring gage
Bearing collar remover
MATERIALS/PARTS: Clean cloths (Appendix C, item 1)
Cleaning solvent P-D-680 (Appendix C, item 2)
Non-hardening sealant (Appendix C, item 10)
Lubricating oil (Appendix C, item 15)
Paint (Appendix C, item 22)
Oil-soluble grease (Appendix C, item 26)
Transmission gasket kit (FSCM 73342 PN 6838897)
REFERENCE: TM 5-3805-262-20
NOTE
PRELIMINARY PROCEDURE: Torque converter group removed
torque converter housing removed (page 4-112), and parking
(refer to TM 5-3805-262-20).
REMOVAL (SHEET 1 OF 2)
4-134
(page 4-94),
brake removed
(1) Remove turbine driven gears and
freewheel unit (1 thru 16) from
transmission housing as an as-
sembly.
(2) Remove 19 capscrews (17) and
lock washers (18).
