INSTALLATION (SHEET 1 OF 3) - TM-5-3805-262-34

CLEANING, INSPECTION, AND REPAIR (SHEET 2 OF 3)

e. Reverse Clutch and Planetary Group (Cont)

TM-5-3805-262-34 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
1093

TM 5-3805-262-34 4-3. TRANSMISSION MAINTENANCE (CONT) e. Reverse Clutch and Planetary Group (Cont). CLEANING, INSPECTION, AND REPAIR (SHEET 3 OF 3) NOTE Repeat steps (h) through (o) above for three remaining pinion gears (13) of matched pinion gear set (13). (3) (4) (5) (6) (7) (8) (9) Use spring gage to check spring (2) compression under load. Replace spring (2) if pressure required to compress spring to 4.80 inches is not 45.1 to 49.9 pounds. Check clutch plates (4 and 5) with a straight edge to be sure they are flat. If a clutch plate is not flat, replace it. Inspect clutch plates (4) for smooth or almost smooth surface. If smooth or almost smooth surface is seen, replace clutch plate. Inspect clutch plates (5) for pitting, scoring, and other damage. Replace as necessary. NOTE Replace an item if inspection indicates need for replacement. Inspect clutch plates (4 and 5) for burrs, embedded metal particles, se- verely pitted faces, excessive wear, cracks, distortion, or damaged spline teeth. Inspect sun gear (7) for cracks or chipped, nicked, burred, broken, or missing teeth. Inspect anchor and pin assembly (3) and reverse clutch piston (6) for cracks or distortion. INSTALLATION (SHEET 1 OF 3) (1) Install new seal (10) in inner groove of reverse clutch piston (6). Use 5/8 inch diameter rod to push seal into position. (2) Install new seal (9) in center groove of reverse clutch piston (6). Use 5/8 inch diameter rod to push seal into position. (3) Install new seal (8) in outer groove of reverse clutch piston (6). 4-168

Privacy Statement
Press Release
Contact