TM 5-3805-262-34
4-8. HYDRAULIC PUMP MAINTENANCE (CONT)
DISASSEMBLY (SHEET 3 OF 3)
p.
q.
r.
Unscrew and remove four studs (27) from shaft end cover (34).
Remove thrust plate (28) and six pocket seals (29) from shaft end cover (34).
Discard pocket seals.
Remove shaft end cover (34) from vise and put in position on bench. Remove
seal (32) using punch and hammer as shown. Discard seal.
NOTE
Do not remove bearings (6, 18, and 30), seals (7, 19, and 31), dowel
pins (8, 12, 20, and 26), or plug (33) unless inspection indicates these
parts require replacement. Removal and replacement of these parts is
covered in inspection and repair on page 4-270.
4-268
