TM 5-3805-262-344-8. HYDRAULIC PUMP MAINTENANCE (CONT)DISASSEMBLY (SHEET 2 OF 3)c.d.e.f.g.h.i.j.k.l.m.n.o.Remove four nuts (1) and washers (2).Hit port end cover (3) using rubber malletto loosen it from gear housing (9).Remove port end cover (3) with installedparts (4 thru 8) as an assembly from gearhousing (9).Remove thrust plate (4) and six pocket seals(5) from port end cover (3). Discard pocketseals.Remove gear housing (9) with installed parts(10 and 11) as an assembly from bearing car-rier (15).Remove and discard seals (10 and 11) from gear housing (9).NOTEPut an identification tag on drive gear (13), driven gear (14), andbearing carrier (15) so that gears can be installed in correct boresduring reassembly.Remove drive gear (13) and driven gear (14).Remove bearing carrier (15) with installed parts (16 thru 20) from gear hous-ing (24).Remove two thrust plates (16)(15). Discard pocket seals.Remove connecting shaft (21)and 12 pocket seals (17) from bearing carrierfrom drive gear (22).Remove gear housing (24) with seals (25) and dowel pin (26) from shaft endcover (34).Remove and discard two seals (25) from gear housing (24).NOTEPut an identification tag on drive gear (22), driven gear (23), and gearhousing (24) to aid reassembly.Remove drive gear (22) and driven gear (23).4-266
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
