TM 5-3805-262-34INSTALLATION (SHEET 1 OF 5)NOTESpray all terminals and contacts with electrical cleaner and allow toair dry before making connections.(1)( 2)( 3)( 4)( 5)(6)( 7)( 8)( 9)(10)(11)(12)Route front wiring harness through hole located in cab floor plate.Route front wiring harness two instrument cluster connectors to left in-strument panel beneath instrument cluster.Connect instrument cluster connectors to instrument cluster. Do this bygrasping with fingers, aline with pins on instrument cluster, and pressonto pins firmly.Connect front wiring harness violet wire terminal to voltmeter IGN termi-nal.Connect front wiring harness gray wire bullet terminal to voltmeter wireterminal. Do this by grasping both in your fingers, alining, then firmlypushing together.Route front wiring harness orange-black wire over to auxiliary steeringrelay socket assembly located just below left instrument panel. Connectbullet terminal of this wire to 3-way connector to which relay socketblack wires are connected.Position front wiring harness blue and white-blue wires on steering col-umn. Connect these wires to associated turn signal switch wires. Do thisby grasping both terminals to be connected in your fingers, alining, thenfirmly pushing together.At front wiring harness gray-white and brown-red wires, separate fuse-holder halves by grasping with fingers, pushing together, twisting coun-terclockwise, and pulling apart.Install 40 ohm resistor in each fuseholder half on gray-white andbrown-red wires. Assemble fuseholder halves by grasping both with fin-gers, alining, then firmly pushing together and twisting clockwise.Connect front wiring harness block-type connectors to ignition key switchand blackout lights wiring harness. Do this by alining connector slotswith tabs and pushing firmly.Connect front wiring harness vehicle lights connector to vehicle lightsswitch connector. Do this by alining groove in harness connector with tabin vehicle lights switch connector, pushing firmly, and turning connectornut clockwise.Refer to table on page 3-258 and connect front wiring harness terminalsto right instrument panel components.3-257
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business