INSTALLATION (SHEET 2 OF 5) - TM-5-3805-262-34

a. Front Wiring Harness (Cont) - TM-5-3805-262-34_417

TM-5-3805-262-34 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
401

TM 5-3805-262-34 3-6. WIRING HARNESSES MAINTENANCE (CONT) a. Front Wiring Harness (Cont). INSTALLATION (SHEET 2 OF 5) (13) (14) (15) (16) (17) (18) (19) (20) (21) (22) (23) Install three tie straps to secure blackout lights wiring harness to front wiring harness. Use one tie strap to secure front wiring harness turn signal switch wires to steering column. Beneath cab deck, route front wiring harness connector over to rear wir- ing harness connector. Route front wiring harness connector over to cab lower wiring harness connector. Connect these two connectors together by alining connector slots with tabs and firmly pushing together. Install tie strap on front wiring harness near its mating connector with cab lower wiring harness connector. Thread tie strap through hole in cab floor cross member and around front wiring harness. Route front wiring harness two connectors and terminal to which four black wires are connected over to hydraulic control valve. Connect front wiring harness connector to which three wires are connected to hydraulic control valve lift solenoid connector. Connect remaining connector to which two wires are connected to hydraulic control valve bucket tilt solenoid connector. Do this by alining groove in harness con- nector with tab in solenoid connector, pushing firmly, and turning con- nector nut clockwise. Connect front wiring harness brown-white wire from lift solenoid connec- tor to black wire. Do this by alining bullet terminals and firmly pushing together. Connect front wiring harness blue-white wire from bucket tilt solenoid connector to white wire. Do this by alining bullet terminals and firmly pushing together. Connect front wiring harness terminal to which four black wires are ter- minated to hydraulic control valve front mounting capscrew. Install re- maining hardware on capscrew and tighten securely. Route front wiring harness terminal to which two gray-white wires are connected over to hydraulic filter. Connect this terminal to filter switch installed in filter head. Tighten hardware securely. Route front wiring harness white-orange wire and black-white wire over to stop light switch. Connect these wires to stop light switch. Tighten hardware securely. 3-262

Privacy Statement
Press Release
Contact