TM 5-3805-262-34
REMOVAL (SHEET 1 OF 3)
(1)
(2)
(3)
(4)
At cab switch panel, remove
HEAT CONTROL knob by pulling
straight up off control shaft.
Remove four screws and care-
fully pull cab switch panel up
from heater console just enough
to gain access to cab console
wiring harness wire terminals
on back of cab switch panel.
At FRONT WIPER switch, discon-
nect cab console wiring harness
tan-black, orange-blue, and
black-yellow wires spade termi-
nals from switch terminals. Do
this by grasping spade terminal
with finger and firmly pulling
from switch terminals.
At HEATER FAN switch, disconnect
cab console wiring harness white
wire terminal from switch ter-
minal. Do this by loosening and
removing screw.
3-311
