TM 5-3805-262-343-9. FRONT AND REAR AXLES MAINTENANCE (CONT) c. FrontAxlePlanetary Assemblies(Cont).DISASSEMBLY (SHEET 1 OF 2)(1)(2)(3)(4)(5)(6)Remove three setscrews (11).Put planetary gear spider (3) inhydraulic press, face down.Using 1-3/4 inches diameter rod,press three pinion shafts (12)from planetary gear spider (3).Remove and discard three O-rings(13) from groove on pinionshafts.Remove three thrust washers (14).Remove three pinion gears (15).Remove three thrust washers (16).NOTEDon’t perform following step unless inspection indicates replacement ofthrust buttons (17 and 18) is necessary.This will be indicated bylubricant stains on outside of planetary gear spider (3) in area thatthrust buttons are installed.(7)(8)(9)(10)(11)(12)(13)3-370Remove three thrust buttons (17) using 1/4 inch point drive pin punch andhammer bearing on shaft of thrust button. Remove thrust button (18) using3/4 inch point drive pin punch and hammer.Remove retaining ring (19), then remove sun gear (20) from axle shaft (4)using puller.Remove cone and rollers (21) from ring gear hub (10).Put wheel hub (31) in hydraulic press,brake disk (26) side down.Press cone and rollers (22) and oil seal(23) from wheel hub (31) using 4-1/4inches diameter sleeve. Discard oilseal.Remove 16 capscrews (24), washers (25),and four dowels (27).Remove brake disk (26) from wheelhub (31).
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business