TM 5-3805-262-34
[ 3-9. FRONT AND REAR AXLES MAINTENANCE (CONT)
c. Front Axle Planetary Assemblies (Cont).
DISASSEMBLY (SHEET 2 OF 2)
NOTE
Perform following steps only if inspection indicates replacement is
necessary.
(14) Remove two bearing cups (28 and 29) from wheel hub (31) using 3/4 inch
point drive pin punch and hammer. Discard bearing cups (28 and 29).
Discard mating cone and rollers (21 or 22) if bearing cup (28 or 29)
requires replacement.
(15) If necessary, remove 12 studs (30) from wheel hub (31). Do this by
driving studs from front to rear of wheel hub (31) using hammer.
NOTE
Repeat steps (1) through (15) above to disassemble remaining front axle
planetary assembly.
3-372
