TM 5-3805-262-34
3-9. FRONT AND REAR AXLES MAINTENANCE (CONT)
f. Rear Axle Planetary Assemblies (Cont).
INSTALLATION (SHEET 1 OF 3)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Position and support
Install 21 capscrews
securely.
wheel spindle (39) on end of axle housing.
(38), washers (37), and nuts (36). Tighten nuts
Position caliper adapter (35) on wheel spindle (39) and secure using sev-
en capscrews (34), washers (33), and nuts (32). Tighten nuts securely.
Apply gear oil to rear axle wheel spindle (39).
Pack area between oil seal (23) lips with grease.
Connect chain hoist equipped with nylon straps to wheel hub (31).
Install wheel hub (31) and brake disk (26) on rear axle wheel spindle.
Install ring gear hub (10).
Install wheel bearing nut (9) using wheel bearing nut tool.
(10) Disconnect chain hoist from wheel hub (31).
(11) Rotate wheel hub (31) clockwise and counterclockwise to ensure that cones
and rollers (21 and 22) are fully seated. Tighten wheel bearing nut (9)
using wheel bearing nut tool to 400 lb-ft while rotating wheel hub. Then
loosen nut (9) 1/4 turn.
3-408
