TM 5-3805-262-343-9.FRONTANDREARAXLESMAINTENANCE(CONT)f. RearAxlePlanetaryAssemblies(Cont).REASSEMBLY(1)(2)(3)(4)(5)(6)(7)(8)(9)(10)(11)(12)(13)(14)(SHEET 1 OF 2)If removed, install 12 studs (30) in wheel hub (31). Install by pressinginto hub using hammer.If removed, install two new bearing cups (28 and 29) in wheel hub (31).Firmly seat bearing cups (28 and 29) using hammer and 3/4 inch pointdrive pin punch. Install bearing cups evenly.Position brake disk (26) on wheel hub (31).Install four dowels (27), 16 washers (25), andcapscrews (24). Install dowels in every fourthhole. Tighten capscrews securely.Install three pinion gears (15)on thrust washers (16).Put wheel hub (31) in press, brake disk(26) upward.Lubricate cone and rollers (22) usinggear oil. Put cone and rollers in wheelhub (31).Apply retaining compound to outercircumference of oil seal (23). Putoil seal in position in wheel hub(31), lip of seal upward.Using 6-1/2 inches diameter sleeve,press oil seal (23) into wheel hub (31)until seal stops moving.Lubricate ring gear hub (10)using gear oil.Install cone and rollers (21) on ring gear hub (10). If necessary, use1/4 inch point drive pin punch and hammer to drive cone and rollers even-ly onto hub.If removed, press thrust button (18) and three thrust buttons (17) intoplanetary gear spider (3). Use hammer to seat thrust buttons.Put planetary gear spider (3) inhydraulic press, face up.Put three small inside diameterthrust washers (16) on planetarybody . Be sure tab is installedin planetary gear spider (3)notches.3-404
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
