REASSEMBLY (SHEET 2 OF 2) - TM-5-3805-262-34

f. Rear Axle Planetary Assemblies (Cont) - TM-5-3805-262-34_559

f. Rear Axle Planetary Assemblies (Cont) - TM-5-3805-262-34_561

TM-5-3805-262-34 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
545

TM 5-3805-262-34 3-9. FRONT AND REAR AXLES MAINTENANCE (CONT) f. Rear Axle Planetary Assemblies (Cont). REASSEMBLY (15) (16) (17) (18) (19) (20) (SHEET 2 OF 2) Install three large inside diameter thrust washers (14) on pinion gears (15). Be sure tab is installed in planetary gear spider (3) notches. Install three new O-rings (13) in grooves of pinion shafts (12). Install three pinion shafts (12) in planetary gear spider (3). Be sure that holes in pinion shafts are alined with setscrew (11) holes. Aline pinion shaft (12) match mark with groove in planetary gear spider. Press three pinion shafts (12) into planetary gear spider (3). Install and tighten three setscrews (11). Put sun gear (20) in position on axle shaft (4). Seat sun gear using 2-1/2 inches inside diameter sleeve and hammer. Seat until retaining ring (19) can be installed in its groove. Install retaining ring. NOTE Repeat above steps to reassemble remaining rear axle planetary assembly. 3-406

Privacy Statement
Press Release
Contact